Table of Contents
xgixp - XGI XP video driver
Section "Device"
Identifier "devname"
Driver "xgixp"
...
EndSection
xgixp is an Xorg driver for XGI XP video cards. The driver is
accelerated, and provides support for the following framebuffer depths:
1, 4, 8, 15, 16, and 24. Multi-head configurations are supported. The XvImage
extension is supported.
The xgixp driver supports PCI,
AGP, and PCIE video cards based on the following XGI chips:
- Volari 8300
Please refer to xorg.conf(5)
for general configuration
details. This section only covers configuration details specific to this
driver.
The following driver Options are supported:
- Option "SWCursor" "boolean"
- Enable or disable the SW cursor. Default: off.
- Option "NoAccel" "boolean"
- Disable or enable acceleration. Default: acceleration is enabled.
- Option
"shadow" "boolean"
- Turn off shadow registers. If you only see a partial
display - this may be the option for you. Default: on.
- Option "stretch" "boolean"
- Turn on stretching. When the resolution is lower than the LCD's screen, this
option will stretch the graphics mode to fill the entire LCD. Default: off.
- Option "ShadowFB" "boolean"
- Enable or disable use of the shadow framebuffer
layer. Default: off.
- Option "VideoKey" "integer"
- This sets the default pixel
value for the YUV video overlay key. Default: undefined.
- Option "Display"
"string"
- Override the display. Possible values are "CRT", "LCD", "TV", and
"DVI". Please note that this option is only experimentally. Default: Use
display active when X started.
- Option "GammaBrightness" "string"
- Set display
gamma value and brightness. "string" is "gamma, brightness", where gamma
is a floating point value greater than 0 and less or equal to 10. brightness
is an integer value greater or equal to 0 and less than 128. Default: gamma
and brightness control is turned off. Note: This is not supported on all
chipsets.
Xorg(1)
, xorg.conf(5)
, Xserver(1)
, X(7)
Author: Andrea
Zhang
Table of Contents